Field evidence
Follow Water Through the Cycle
Useful dishwasher cases preserve when water enters, circulates, heats and drains, plus where a leak or control decision interrupts that sequence.
All dishwasher diagnostic cases
Documented field evidence
Whirlpool Dishwasher Leaks at the Right Door for Only Part of the Cycle
A Whirlpool leaked at the right door for five minutes in one cycle phase. Timing and a failed pump anecdote point toward spray direction …
Documented field evidence
Whirlpool or KitchenAid F9E1 Only at the End of a Cycle
F9E1 appeared only near the end of a cycle even though Cancel drained normally. See why intermittent restrictions can escape short tests.
Documented field evidence
Samsung Top Rack Not Washing After Diverter Parts
A Samsung upper rack still did not wash after motor and diverter-system parts. The case remained open, with settings and water delivery still to …
Documented field evidence
Miele Dishwasher Waterproof Message: Leak Protection Has Activated
A Miele Waterproof message indicates leak protection has activated. The exact source still requires model-specific drain, valve and sensor diagnosis.
Documented field evidence
Miele G843plus IV Intake/Drain Light After Five to Seven Minutes
A Miele G843plus IV stopped after five to seven minutes with Intake/Drain flashing. Water in the base redirected diagnosis from the drain pump.
Documented field evidence
LG LDF5545ST Freezes, Blinks or Will Not Start Intermittently
An LG LDF5545ST froze mid-cycle, sometimes would not start and changed after resets. Prior UI results guided but did not confirm diagnosis.
Documented field evidence
KitchenAid KUDD03DTSS3 Poor Drying in Both Drawers
Both drawers of a KUDD03DTSS3 dried poorly although the fan ran. The case follows its hidden heating path and parts-availability constraint.
Documented field evidence
Kenmore 665.13922K010 Fills for 5–10 Seconds, Clicks, Then Stops
Kenmore 665.13922K010 filled for 5–10 seconds, clicked and stopped. See the unresolved water-level versus circulation-motor split.
Documented field evidence
GE Monogram ZDT985SIN6II Had Both Pumps Inactive in Test Mode
A GE Monogram ZDT985SIN6II would not drain, and neither pump ran in diagnostics. The case puts voltage, wiring, debris and air-gap checks before the …
Documented field evidence
GE GDT630PYR0FS Panel Blinked and Ignored Input
A GE GDT630PYR0FS panel blinked, ignored input and exited test mode immediately. The working branch was main-board-to-interface communication.
Documented field evidence
GE GDT605PSM0SS Door-Open Beep After Latch Replacement
GE GDT605PSM0SS units beeped as if open after new latches. Learn how comparable cases separated latch alignment from board failure.
Documented field evidence
Fisher & Paykel DD24SCX7: P1 Wash-Motor Test Does Not Run
A DD24SCX7 only beeped and would not start. P1 did not run the wash motor while P2 attempted to drain, narrowing but not completing …
Documented field evidence
Cove DW24 Error 800140: Start with the Drain Path
A real Cove DW24 case explains what error 800140 supports, what it does not prove, and how to separate the drain pump, hose and …
Documented field evidence
Bosch SHX78CM5N Dishwasher Dead After Panel Replacement
A Bosch SHX78CM5N/22 died after panel work. New UI and control did not help, shifting attention to the disturbed signal path.
Documented field evidence
Bosch SHE3AR72UC/25 E15 Without a Lower Base Pan
A Bosch SHE3AR72UC/25 showed E15 with water inside but no familiar lower flood tray. The case follows the float-input and overfill branches.
Documented field evidence
Bosch E24 Returned After the Drain Pump Was Replaced
A Bosch drained completely after a new drain pump but E24 returned. The case explains why circulation-pump rotor play became the next check.
Documented field evidence
Viking DFUD242 Dishwasher Drains but Will Not Fill
A Viking DFUD242 ran its initial drain but never filled. With no valve supply reported, the float input and control command remained the key …
Documented field evidence
GE Dishwasher No Heat: High-Limit and Thermal-Fuse Path
A GE no-heat diagnosis missed the fuse path after other parts. Learn why the high-limit temperature rating must match the exact model.
Documented field evidence
Frigidaire Gallery Dishwasher Er and ErCl: Keypad or Interface Path
A Frigidaire Gallery Er code leads through stuck keys, keypad wiring and the user interface before a main-board replacement is considered.
What makes two similar complaints different
Note the exact cycle stage, water level, drain behavior, heating result, leak location and code timing. Also record any control or pump already replaced and whether programming or configuration was completed afterward.
The same symptom can have a different cause. A drain code can reflect a restriction, a pump, wiring, sensing or an installation condition, depending on the evidence.
A useful service record
- Model number and exact code, including when it appears.
- Whether the tub fills, circulates, heats and empties.
- Visible water location rather than only “it leaks.”
- Recent installation, disposal or drain-hose changes.
- Previous parts, programming steps and the result.
Safety: shut off power and water after an active leak, burning odor or repeated breaker trip. Do not test exposed wet components while energized.
A repair that did not follow the obvious path
Recently published cases
Whirlpool F03 E01 with Drain Running Forever
A Whirlpool ran its drain forever, flashed the lock lamp and showed F03/E01 after a level-sensor connection changed. The signal path came first.
Maytag MVW7230HW0 Quick Wash Stuck at 17 Minutes
A Maytag MVW7230HW0 kept operating while Quick Wash remained at 17 minutes. The case separates a stalled countdown from a simple no-spin fault.
Maytag F1E2 After Drain Worked and Programs Stopped
A Maytag drained correctly, then programs stopped after pause and F1E2 appeared. The case separates standing-water door lock from motor control.